[Diy_efi] Help with LM3914 (10-segment LED driver)

[Perry Harrington]

The datasheet is quite specific on this point.  You can get it from www.national.com

--Perry

On Sun, Jan 19, 2003 at 02:05:08PM -0800, Derek wrote:
> Anyone tell me the procedure for defining the voltage range to use? I'd like to
> use 1.7V-2.5V as the range of input.

-- 
Perry Harrington			Data Acquisition & Instrumentation, Inc	
perry at dainst dot com					 http://www.dainst.com/

Those who would give up essential liberty to purchase a little temporary safety
deserve neither liberty or safety. Nor, are they likely to end up with either.
                             -- Benjamin Franklin

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi