[Diy_efi] PC-laptop based efi

[Marcell Gal]

Hi,

> I took a look at the MegasquirtAVR, and have emailed regarding buying a
> component build kit, and have sent off a message to Atmel asking for a few
> samples (we'll see if they send them) Overall, it looks quite good to me.
I
> like the flexibility, and support. Is there anywhere where i can buy the
pcb
> without having to wait for the next group buy?? Anyone??

There's a few PCB's stocked.
http://www.x-dsl.hu/genboard/
(I guess you don't want a fully assembled board?).
Postal address is important. I suggest 2 solder-protected boards
(3+11*2 = 25 Euro with airmail shipping), since
 you might want to build a 2nd unit later to have a backup.
Also the L293NE stepper driver and MC34151P FETdriver chips are
cheap (5 and 1 Euro respectively), but you might find it frustrating
to get them in small quantities. (better spend your energy elsewhere).
But if you'll get AAron's kit, it contains these.

     Marcell

2.5 bar ported MAP sensor also available in limited quantity (23Euro).


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi