[Diy_efi] Holley projection help needed

[Ray Drouillard]

I don't recall the serial number, but I got a new O2 sensor from Auto Zone
by taking the old one in and matching up the connector.  I believe (it was a
long time ago) I used an ohm meter to verify that the heater leads were on
the same pins for both sensors.  The swap worked great.

I tried the same thing with the MAP sensor, but I never got it to work right
(the profile was actually reversed).  I ended up ordering a new one from
Holley.  When I get my Jeep back on the road, I plan on ordering a spare.


Ray Drouillard


----- Original Message -----
From: "Jeff Behrens" <jwg94 at yahoo.com>
To: <diy_efi at diy-efi.org>
Sent: Monday, June 02, 2003 11:09 AM
Subject: [Diy_efi] Holley projection help needed


> Another question.  Does anyone know of the bosch
> sensor numbers that will work with the projection.  I
> need the map sensor and the O2 sensor.
>
>
> Jeff
> Automation specialist
>
> __________________________________
> Do you Yahoo!?
> Yahoo! Calendar - Free online calendar with sync to Outlook(TM).
> http://calendar.yahoo.com
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
>



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi