[Diy_efi] Looking for Bosch MAF pin out

[Alexei Pavlov]

cice at trub.com wrote:
> 
>  > From: Mike <erazmus at iinet.net.au>
>  >
>  > Well it should be quite easy to work it out,
>  >
>  > -One pin is likely to be DC power, either 12v or 5v -        One pin is
>  > likely to be DC ground
>  > -One pin is likely to be signal out
>  > -Last pin is likely to be either temperature or signal correction - is
>  > there a pot on the side of the AFM ?
> 
> Understood...trick is, which is which. :)  12v in the wrong spot and fiszt.
> 
> Someone sent me a pdf which is exactly what I need I think.  I don't
> know if mailing me off-list was intentional, but if so, the pdf may or
> may not be copyrighted and not ok to send publically.  If there's
> interest, I'll ask the sender if they are comfortable sending to all or
> contact me direct.

You can put the file on the FTP with a clear name, like
Bosch_MAF_pinout.pdf

Is it a hot-wire MAF ? 4 pin (in fact 5 pins with 1 broken) connectors
are
usual on VW flap MAFs, hot-wire MAFs I've seen had more pins.

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi