[Diy_efi] I really hate to make this my first contribution to the

[Steve Ravet]

> -----Original Message-----
> From: diy_efi-bounces at diy-efi.org=20
> [mailto:diy_efi-bounces at diy-efi.org] On Behalf Of Cracker Matt Parsons
> Sent: Monday, April 12, 2004 6:06 PM
> To: diy_efi at diy-efi.org
> Subject: [Diy_efi] I really hate to make this my first=20
> contribution to the list...
>=20
> But I need some help.  I just bought a used DFI 6 (74024) box=20
> for my 86 TPI Camaro and I desperately need a dfi wiring=20
> schematic.  The DFI harness has the distributor plug for my=20
> original distributor, but that distributor has been replaced=20
> with the smaller, external coil model for clearance reasons. =20
> Now I have the schematic for the TPI harness but I can't find=20
> one for a Gen6, and Accel tech takes forever to respond. =20

You need to convert the DFI from large cap HEI to small cap?  Take a =
look at this:

ftp://diy-efi.org/uploads/7PIN_SCH.GIF

>=20
> I'd also like to see the diagram that relates to the=20
> converter lockup.  I'm hoping I can wire that myself and=20
> avoid buying the harness. Yeah, I'm a cheapskate!

Should be in your service manual (even cheapskates need service =
manuals).  Or, look here:

http://diy-efi.org/gmecm/ecm_info/1227165/

Click on F body schematic page 5.  There's more to this circuit inside =
the transmission than is shown here but this is enough to wire it up on =
the outside.  The IAC connector is compatible with the TCC connector =
once you cut off the keying tabs.

--steve


_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi