[Diy_efi] TBI in boat

[demon]

> > -----Original Message-----
> > From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org=
]
> > On Behalf Of Wallace O. Powelle
> > Sent: Saturday, August 07, 2004 10:26 PM
> > To: diy_efi at diy-efi.org
> > Subject: [Diy_efi] TBI in boat
> >
> > I'm going to put a TBI system of of a 305 chevy on my Volvo Penta 305=
.
> > Any advice or words of warning would be appreciated. Should I be able=
 to
> > get by with the factory prom, Is there a built in rev limit, does any=
one
> > know of a source for a spacer to install O2 sensor between manifold &
> > riser?  Thanx, Wallace
>=20


I just got done doing a TPI setup in my 21' cuddy with a=20
350 - I had to make my plate from 1 1/4" thick steel. As=20
far as I know, nobody makes one. Pics of the whole project=20
are at http://www.demonden.com:8080/boat/

Mark
_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi