[Diy_efi] ECU Tester

[Scott Pearson]

Someone correct me if I'm wrong here, but this sounds like a great idea for 
an ECM bench.

I'd be more than happy to help with the GM side, drop me a line offlist and 
we'll chat about it. Might be a topic that's better moved or cc'd to the 
gm_ecm list.

Scott
mrcad472 at iowatelecom.net


----- Original Message ----- 
From: "K DANIEL" <kml_daniel at yahoo.com>
To: <diy_efi at diy-efi.org>
Sent: Saturday, October 30, 2004 6:49 AM
Subject: [Diy_efi] ECU Tester


>
> Hello
>
> I'm new member to DIY-EFI .. I'm engineer I have designed an engine 
> simulator for testing engine
>
> ECU's the simulator generate all the sensors signals required operate the 
> ECU under test
>
>  I'm using LABview software to monitor and control the ECU operation
>
> By now most of the BOSCH MOTRONIC ECU's can be tested...I'm now preparing 
> the simulator
>
> For testing SIMTEC and GM ecru's but the information on SIMTEC and GM ECU 
> is very rare... any one can help with
>
> the pinout or schematics of SIMTEC and GM ECU's
>
> 
> K Daniel
>
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! Mail Address AutoComplete - You start. We finish.


--------------------------------------------------------------------------------


> _______________________________________________
> diy_efi mailing list
> diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> 



_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi