[Diy_efi] Sequential on a 2-stroke

Gianmarco Rizzo (BE/EAS) gianmarco.rizzo at ericsson.com
Wed Nov 10 10:12:24 GMT 2004


you can alternatively check if this can be used

http://www.jefferies-au.org/My16M/

or contact Cliff, he might mod the firmware to suit a 2 stroker.

gm


-----Original Message-----
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org]On
Behalf Of joeld
Sent: Dienstag, 9. November 2004 16:41
To: diy_efi at diy-efi.org
Subject: [Diy_efi] Sequential on a 2-stroke


Hello all,

I've got a project going where I need to sequentially inject a snowmobile 
engine. The motor is a twin, so each cylinder is 180 out from the other. 
Anyhow, I would like to inject fuel at 100 btdc on both cylinders. Who makes a 
controller that can do this?

Thanks,

Joel

_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi
_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi



More information about the Diy_efi mailing list