[Gmecm] startup idle parameters

[DV Fagan]

David,
Don't play with the ECM PROM until you manually set
the idle speed (throttle blade stop) in the TBI.  You
can find out how at thirdgen.org.
Dennis

--- David Sword <dsword at scu.edu> wrote:

> This is probably a newbie question but my idle at
> startup seems to stay high way too long.  What is
> the name of the parameter to change this?  Also,
> after the engine is up to operating temp the startup
> idle is a high for a little too long.  I assume this
> is a different parameter.  This is for a TBI setup
> on a Chevy 350 with a 7747 ECM.  I have a flash
> chip, programmer and TunerPro.
> 
> Thanks, David Sword
> 
> 
> 
> 
> This message scanned for viruses and SPAM by
> GWGuardian at SCU (MGW1)
> _______________________________________________
> Gmecm mailing list
> Gmecm at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/gmecm
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm