[Diy_efi] Toyota 2F - TBI Install

[Robert W Hughes]

> This is my first post on this list.
> I have a Toyota Land Cruiser FJ60 with 2F engine. I'm installing a TBI system from 4.3 V6 GM TBI.
> at list i have installed an adapter plate, Fuel pump, GM HEI with 7 pin module, 1227747 ECM with reprogramed CHIP for 2F, O2, Water Temp.
> I don' have VSS for the moment.
> When I crank, the injectors start, and the engine start for about 5 seconds and stop, some times for 30 seconds, but nothing more.
> anyone have an idea?

did you wire up the complete GM fuel pump circuit including the oil 
pressure switch? A lot of the GM ECMs turn the pump on for a few seconds 
at key on and then rely on the oil pressure switch to turn the pump back 
on and keep it running.
-- 
Robert W. Hughes (Bob)
BackYard Engineering
29:40.237N, 95:28.726W or perhaps 30:55.265N, 95:20.590W
Houston, Texas "The city with too much Oxygen"
rwhughe at oplink.net
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi