[Diy_efi] Toyota 2F - TBI Install

Tue Aug 23 15:23:16 UTC 2005

I don't have Oil pressure switch

----- Original Message ----- 
From: "Robert W Hughes" <rwhughe at oplink.net>
To: <diy_efi at diy-efi.org>
Sent: Tuesday, August 23, 2005 10:50 AM
Subject: Re: [Diy_efi] Toyota 2F - TBI Install


>> This is my first post on this list.
>> I have a Toyota Land Cruiser FJ60 with 2F engine. I'm installing a TBI 
>> system from 4.3 V6 GM TBI.
>> at list i have installed an adapter plate, Fuel pump, GM HEI with 7 pin 
>> module, 1227747 ECM with reprogramed CHIP for 2F, O2, Water Temp.
>> I don' have VSS for the moment.
>> When I crank, the injectors start, and the engine start for about 5 
>> seconds and stop, some times for 30 seconds, but nothing more.
>> anyone have an idea?
>
> did you wire up the complete GM fuel pump circuit including the oil 
> pressure switch? A lot of the GM ECMs turn the pump on for a few seconds 
> at key on and then rely on the oil pressure switch to turn the pump back 
> on and keep it running.
> -- 
> Robert W. Hughes (Bob)
> BackYard Engineering
> 29:40.237N, 95:28.726W or perhaps 30:55.265N, 95:20.590W
> Houston, Texas "The city with too much Oxygen"
> rwhughe at oplink.net
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> 


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi