[Diy_efi] Re: WB board on ebay

[David Cooley]

If the board is assembled, then yes, all that is left is the Sensor.
And these boards do provide a 0-1V output.
 

> -----Original Message-----
> From: diy_efi-bounces at diy-efi.org 
> [mailto:diy_efi-bounces at diy-efi.org] On Behalf Of LajoieG
> Sent: Wednesday, February 09, 2005 2:32 PM
> To: diy_efi at diy-efi.org
> Subject: [Diy_efi] Re: WB board on ebay
> 
> Hi everyone,
> 
> This is my first post to the digest.  I hope it .
> 
> I have a question regarding the WB board on e-bay.  Can 
> anyone explain to me (in a nutshell) what else would be 
> needed to complete this wideband kit other than the sensor?  
> Does this particular design have an output that emulates the 
> signal of a narrow-band sensor that can be used on an engine 
> management system that doesn't have the capability to run a 
> wideband sensor?
> 
> I've been reading up on wide-band sensors lately but I am not 
> familiar with the diy kits and since I'm not familiar with 
> soldering such small components it's not something I would 
> undertake on my own.  A partially assembled kit would 
> interest me depending on what is left to do to complete it 
> and make it functional.
> 
> Thanks in advance,
> 
> Gilles Lajoie
> 1974 Datsun 260Z turbo
> 
> 
> _______________________________________________
> diy_efi mailing list
> diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> 

_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi