[Diy_efi] Choice of labscope

[Robert W Hughes]

Check out the Tektronix TDS1000 series. Although rated for an analog 
bandwidth of 60Mhz it samples at 1Ghz. I have an older version, the 
TDS210 and it works very well with usable response up to around 100Mhz. 
If you get the comm module you can upload screens from the scope and the 
FFT function lets you use it as a spectrum analyser, or just see the 
frequency response of signals such as knock sensors. It can also measure 
frquency, time and voltage of displayed signals. At about $1000 it is a 
bargain, performance wise.
-- 
Robert W. Hughes (Bob)
BackYard Engineering
29:40.237N, 95:28.726W or perhaps 30:55.265N, 95:20.590W
Houston, Texas "The city with too much Oxygen"
rwhughe at oplink.net

_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi