[Diy_efi] Speed Sensor

[Donald Schlaud]

I would go with the JTR sensor that hooks into your speedomotor cable.  If 
the transmission was electronic (my 94 4l60E truck is) you will want to 
program the PCM with a manual transmission binary so that it is not looking 
for the auto shift solenoids.  The speedo signal is definitely needed for 
the PCM to determine the proper fuel and idle cells to use.

Regards,
Don Schlaud II


>From: "Clayton Martiniuk" <wildwood at aptalaska.net>
>Reply-To: diy_efi at diy-efi.org
>To: "A list for Do-It-Yourself EFI" <diy_efi at diy-efi.org>
>Subject: [Diy_efi] Speed Sensor
>Date: Fri, 22 Jul 2005 15:43:04 -0700
>
>Looking for some help, trying to figure the best way to get a vss signal to 
>my 94 5.7. I have this motor in an 86 chevy truck. The motor came out of an 
>suburban with a 4L80. I've heard of a kit that you weld onto your reluctor, 
>not sure if this the best or only way.  thank you
>_______________________________________________
>Diy_efi mailing list
>Diy_efi at diy-efi.org
>http://lists.diy-efi.org/mailman/listinfo/diy_efi