[Diy_efi] AIR fitting

Mike Frels mfrels
Fri Sep 9 12:07:34 UTC 2005


On my '86 Thiird-gen Camaro manifolds when I did my engine swap last year I had to swap the AIR tubes to a different set of '87 and later manifolds to clear the center bold valve cover lips. When I removed the tubes I noted that the fittings and the flair on the tubes looked just like the steel brake lines with fittings that can be bought at any auto part store. I do not know if they *are* the same. I just noticed that the looked the same.

I don't know if this will help your application but I thought I'd throw it out there as your question brought it to mind.

Mike


-----Original Message-----
From: Steve Ravet <Steve.Ravet at arm.com>
Sent: Sep 8, 2005 11:58 PM
To: diy_efi at diy-efi.org
Subject: RE: [Diy_efi] AIR fitting

What a poorly asked question...  well, it's late.

The engine in question is a TBI chevy 350 ('91 Caprice).

--steve

> -----Original Message-----
> From: diy_efi-bounces at diy-efi.org 
> [mailto:diy_efi-bounces at diy-efi.org] On Behalf Of Steve Ravet
> Sent: Thursday, September 08, 2005 11:53 PM
> To: diy_efi at diy-efi.org
> Subject: [Diy_efi] AIR fitting
> 
> anyone know what kind of fitting the AIR tubes use where they 
> attach to
> the exhaust manifold?
> 
> thanks,
> --steve





More information about the Diy_efi mailing list