[Diy_efi] Air leak through the allen key adjuster

[Adam Wade]

--- Bill Washington <bill.washington at nec.com.au>
wrote:

> Would a drop of Loctite 'locknut' on the thread
> seal the thread, stop the leak, and still allow
> adjustment?

The threads are not the problem.  The adjustment screw
is accessed on the engine side of the airflow metering
plate, and you have to remove a rubber plug that
allows access to the screw to make adjustments.  That
causes an air leak, which leans the vehicle out.

| Kawasaki Zephyr 615 (Daphne)       Kawasaki Zephyr 550 (Velma)|
| "It was like an emergency ward after a great catastrophe; it  |
|   didn't matter what race or class the victims belonged to.   |
|  They were all given the same miracle drug, which was coffee. |
|   The catastrophe in this case, of course, was that the sun   |
|     had come up again."                    -Kurt Vonnegut     |
| M/C Fuel Inj. Hndbk. @ Amazon.com -  http://tinyurl.com/6o3ze |

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com