[Diy_efi] some pictures...

[Ian Molton]

Geoff Harrison wrote:
> Hi Ian. If it wont budge with a bearing puller, you could try
> a nut splitter, or a good whack with a coal chisel with the race
> on a hard surface in a way where it can't roll. Watch out for
> shattering pieces. If you have access to a lathe and an air driven
> grinder, grind it down to within a few mm of the shaft, and it
> will fall into pieces.

Ok next question is which end of the shaft it goes on... is it possible 
it goes on from the 'thin' (intake) end ?

if not, how on earth do I remove the exhaust turbine from the shaft?

I dont want to damage the central part of the shaft since the bronze 
sleeve goes on there.

What 'kind' of turbo is this anyway? I thought they were either ball 
bearing or floating sleeve - this is both?