[Diy_efi] Nissan engine
Tom Visel
five10man
Thu Jun 1 16:46:41 UTC 2006
It has an easy-to-access terminal for the single small wire at the
solenoid. Easy job with a screwdriver and the ignition off.
TomV
Bill Shaw wrote:
>If you're concerned about it you could always pull the fuse to the ECU.
>
>Bill
>
>
>
>
>>From: "Bobby Yates Emory" <liberty1 at gmail.com>
>>
>>Ian,
>>
>>Restart procedure sounds about right, but I would use Marvel Mystery Oil.
>>Put a couple of tablespoons down each cylinder. Let sit over night (or a
>>day or two). Put another tablespoon down each cylinder. Turn engine over a
>>few rounds with a socket on the harmonic balancer bolt (sparks plugs out and
>>ignition off). With the plugs still out, turn over a few times with the
>>starter (this is to get all the excess oil out of the cylinders). Then
>>install plugs and try to start up.
>>
>>(Caution - I have heard that electronic ignitions can be damaged by running
>>the engine with one or more wires off the plugs. So it may be worth your
>>while to rig up a way to "hit" the starter, without turning on the
>>ignition. I don't remember how the starter solenoid worked on my 240Z, but
>>usually there is a small stud on the solenoid which you can put 12 V to and
>>it kicks in the solenoid which connects power and engages the starter
>>drive. I am not certain about this concern - I could be worrying
>>unnecessarily. Anyone know for 280Z?)
>>
>>Good luck,
>>Bobby
>>
>>
>>
>
>_______________________________________________
>Diy_efi mailing list
>Diy_efi at diy-efi.org
>http://lists.diy-efi.org/mailman/listinfo/diy_efi
>
>
>
>
More information about the Diy_efi
mailing list