[Diy_efi] got to get rid of codes

[Steve Ravet]

If you pulled the fuse or disconnected the battery then the codes are
gone.  Just having codes won't put you in limp mode, but the fault that
is setting codes can also keep you in limp mode.  I think you've got
more serious problems -- do you have a spare PCM?

--steve 

> -----Original Message-----
> From: diy_efi-bounces at diy-efi.org 
> [mailto:diy_efi-bounces at diy-efi.org] On Behalf Of 93 Formula
> Sent: Wednesday, June 28, 2006 7:45 PM
> To: diy_efi at diy-efi.org
> Subject: [Diy_efi] got to get rid of codes
> 
> I think my car threw some codes and is stuck in limp mode, 
> and the ecm won't communicate with either of my laptops with 
> either diacom or datamaster so I can't reset the codes. I've 
> tried two ecm bins too.  Is there a way I can wipe out the 
> codes to get the car running again and communicating with the 
> diagnostics?  Before this it had been sitting around since 
> winter, and I just replaced the battery. I have pulled the 
> fuses on the ecm too.
> 
> Jeff  http://FindFastCars.com 93 Formula
> Mods: 355 forged for NOS, LT4 HotTop, 58TB, SLP Cnvrtr, 
> 3.73s, Mufflex/Spintech 4" exhaust, Hooker LTs, 300+ Ign, 
> Injctrs, MSD Adj Win Sw &
> 3 Ign Ret, K&N CAI, Diacom, CATSTuner...
> 
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> 

-- IMPORTANT NOTICE: The contents of this email and any attachments are confidential and may also be privileged. If you are not the intended recipient, please notify the sender immediately and do not disclose the contents to any other person, use it for any purpose, or store or copy the information in any medium.  Thank you.