[Diy_efi] Circuit boards from China fab have arrived - very nice quality

[Steven P. Donegan]

The boards arrived after 2 days - FedEx does darn good on international
orders.

I have populated the first board with the same components as my pure
breadboard setup contained. I expect by tomorrow PM I'll have seen if it
does the MAF interceptor/translator job correctly. In addition the board
(1.25 inches X 3 inches) has support for 5 analog inputs such as IAT,
TPS, CT, O2 sensors etc. Output can drive an LCD panel and an RS-232
port. Not bad for a board with 8 active components on it :-) All
'unused' I/O pins are present on headers - so as the software grows the
hardware will be ready. My only ooops on the board was placing the
crystal pins at .3 inches instead of .2 inches - schematic has been
modified for the next run.

At some point I will offer these for sale if there are any interested
parties out there.
-- 
"Each new law makes only a single guarantee. It will create new
criminals."-- John Tandervold