[Diy_efi] Circuit boards from China fab have arrived - very nice quality

[Mike]

Sorry I must have missed the thread - is this for an EFI controller ?

Curious how much the Fed Ex was from CHina to US ?

Rgds

Mike


At 04:21 AM 9/18/06, you wrote:
>The boards arrived after 2 days - FedEx does darn good on international
>orders.
>
>I have populated the first board with the same components as my pure
>breadboard setup contained. I expect by tomorrow PM I'll have seen if it
>does the MAF interceptor/translator job correctly. In addition the board
>(1.25 inches X 3 inches) has support for 5 analog inputs such as IAT,
>TPS, CT, O2 sensors etc. Output can drive an LCD panel and an RS-232
>port. Not bad for a board with 8 active components on it :-) All
>'unused' I/O pins are present on headers - so as the software grows the
>hardware will be ready. My only ooops on the board was placing the
>crystal pins at .3 inches instead of .2 inches - schematic has been
>modified for the next run.
>
>At some point I will offer these for sale if there are any interested
>parties out there.
>-- 
>"Each new law makes only a single guarantee. It will create new
>criminals."-- John Tandervold
>
>_______________________________________________
>Diy_efi mailing list
>Diy_efi at diy-efi.org
>Subscribe: http://lists.diy-efi.org/mailman/listinfo/diy_efi
>Main WWW page:  http://www.diy-efi.org/diy_efi



Regards from


Mike Massen
Network Power Systems
Lab 08 9444 8961
Mb 0438 048961
Perth, Western Australia
* VL/VK Commodore Fuse Rail that wont warp or melt !
* RB30 Skyline/Nissan/VL Milspec now in economy trials
* Twin tyres for most sedans, trikes and motorcycle sidecars
* Industrial grade PolyVinyliDeneChloride (PVDC Copolymer) in bulk, the best
  oxygen and water protective barrier you can find for circuit boards.
Web site under construction   http://niche.iinet.net.au