[Diy_efi] fuel tank fittings

[ian]

On Wed, 2007-08-29 at 10:17 -0700, Mike Yates wrote:
> We used to weld alot of Ocean Kayak brand kayaks at a boat store i
> worked for and we used a heat gun with a reducing nozzle on it. This
> was the manufacturers recomended method. and they even would sell you
> a kit that was just that, a heat gun with a reducing nozzle, and
> strips of their particular blend of plastic. 

Oh, I dont doubt it can be done - just suggesting some caution. I'd
*definately be trying to source some scrap tanks with similar material
to practice on and test the procedure for good quality repeatable joins.