[Diy_efi] Newbie Question ????

[Mike O'Brien]

Mike

Thanks for the tip.  Removing the Fuse will save a lot of wear and tear on
the harness.

I had a prom error code and re seated the prom in the zif and disconnected
the harness for a few seconds and the re connected everything.  It erased
the error code but the BLM was way off.  I disconnected the ECM for a half
hour and everything was back to normal.

Thanks again,  Mike 

-----Original Message-----
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On
Behalf Of Mike V
Sent: Sunday, February 04, 2007 8:10 PM
To: diy_efi at diy-efi.org
Subject: Re: [Diy_efi] Newbie Question ????

Just pull the ECM fuses for 30 seconds or so.
No need to remove the PROM afaik.
mv