[Diy_efi] Newbie Question ????

[Mike V]

Actually, most GMs of that era have fuses: "ECM-A" and "ECM-B"
One is for driving the injectors, and I can't tell you which,
so best to pull both fuses to clear things.
Cheers,
MV


----- Original Message ----- 
From: "Mike O'Brien" <mmob at wavecable.com>
To: <diy_efi at diy-efi.org>
Sent: Monday, February 05, 2007 12:53 PM
Subject: RE: [Diy_efi] Newbie Question ????


> Mike
>
> Thanks for the tip.  Removing the Fuse will save a lot of wear and tear on
> the harness.
>
> I had a prom error code and re seated the prom in the zif and disconnected
> the harness for a few seconds and the re connected everything.  It erased
> the error code but the BLM was way off.  I disconnected the ECM for a half
> hour and everything was back to normal.
>
> Thanks again,  Mike
>
> -----Original Message-----
> From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On
> Behalf Of Mike V
> Sent: Sunday, February 04, 2007 8:10 PM
> To: diy_efi at diy-efi.org
> Subject: Re: [Diy_efi] Newbie Question ????
>
> Just pull the ECM fuses for 30 seconds or so.
> No need to remove the PROM afaik.
> mv
>
>
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> Subscribe: http://lists.diy-efi.org/mailman/listinfo/diy_efi
> Main WWW page:  http://www.diy-efi.org/diy_efi