[Diy_efi] GM TPI Fuel Rail '86

[Dan]

Absolute champion Aaron. This will do very nicely.

Thanks - Dan

--- On Wed, 8/24/11, Aaron <aaron at creativeoverdrive.com> wrote:

> From: Aaron <aaron at creativeoverdrive.com>
> Subject: Re: [Diy_efi] GM TPI Fuel Rail '86
> To: "'diy_efi'" <diy_efi at diy-efi.org>
> Date: Wednesday, August 24, 2011, 4:31 AM
> Like This ?
> http://www.djgaston.com/scramzilla/tpiswap.htm
> 
> 
> -----Original Message-----
> From: diy_efi-bounces at diy-efi.org
> [mailto:diy_efi-bounces at diy-efi.org]
> On
> Behalf Of Dan
> Sent: Wednesday, August 24, 2011 2:29 AM
> To: diy_efi
> Subject: [Diy_efi] GM TPI Fuel Rail '86
> 
> Has anyone tried to relocate the inlet/return lines on the
> '86 TPI fuel
> rails to be at the back of the engine (near the regulator)
> instead of the
> front (I'm not using the cold start injector so can put
> fittings in that end
> instead)?
> 
> Trying to see if I can make my custom setup a bit neater,
> by having the
> lines run onto the firewall instead of across the front of
> the engine bay.
> 
> Would there be an issue with the regulator ending up
> sitting near the inlet
> pipe instead of at the far end like in the normal setup ?
> 
> Cheers? Dan
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
>