[Diy_efi] Flood of Humvee 6.2L diesel engines on ebay.

[Eck, Joel]

it's bigger than an SBC, I have not owned anything with a BBC so I can't say for certain - I'd guess it's approximately the same size as the BBC.

Someone else might have answers for your other questions.

-----Original Message-----
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On Behalf Of Avery Nisbet
Sent: Tuesday, June 21, 2011 12:06 PM
To: Eck, Joel
Cc: Do It Yourself fuel injection
Subject: Re: [Diy_efi] Flood of Humvee 6.2L diesel engines on ebay.

Also will these engines fit anywhere a chevy small block would go?  Or
are they more like a big block and hard to fit in smaller
applications?


Can the injection pump be converted over to something with an O2
sensor or an electronically controlled pump?  And what applications
could those be found in?

-Avery

On Tue, Jun 21, 2011 at 7:51 AM, Eck, Joel <Joel.Eck at hp.com> wrote:
> I'm no diesel expert, but I picked up a 6.2 powered truck - a basket case - a while back and am working to put together a truck for my son. Here's what I've found in my research:
>
> The military 6.2l injection pumps were mechanical, but the solenoids were 24V instead of 12V. The pump may need to be rebuilt or resealed anyway, and I've seen the 12V solenoid sets on ebay too. It could all be done at one time.
>
> The 6.2L (and the follow-on 6.5L) was a ground-up design where GM had Detroit Diesel build a light-duty V8 diesel - it is not the same as the converted-from-olds-gasser-block 350. http://en.wikipedia.org/wiki/Detroit_Diesel_V8_engine .
>
> >From what I have seen while looking for cheap rebuild parts, I'd say it's probably more in line with non-chevy v8's than with the other pickup diesels you find out there - Cummins, power stroke, etc. But I guess it depends on what you buy and from whom, too.
>
> Some folks complain the roosamaster injection pump doesn't last as long as the pump on a Cummins or a powerstroke, but it doesn't cost as much to have it rebuilt, either.
>
>
> HTH,
> Joel
>
>
> -----Original Message-----
> From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On Behalf Of Avery Nisbet
> Sent: Monday, June 20, 2011 5:58 PM
> To: Do It Yourself fuel injection
> Subject: [Diy_efi] Flood of Humvee 6.2L diesel engines on ebay.
>
> I think this has been happening over the last few years or so.
>
> Do these engines have electronically controlled injection pumps? ?Or
> seeing as the Humvee has been in production since the early 80's are
> they full mechanical?
> If electronically controlled which GM ECM's will work?
>
>
> Relating the the langth of Humvee production how diffrent are these
> engine from the Olds v8 that killed the Diesel market in the US?
>
> Also most are listed as needing a rebuild. Is this going to be a
> extremely expensive or is it much like a normal GM V8 rebuild plus
> slightly more expensive bearings and piston rings?
>
>
> Thanks
>
> -Avery
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
>
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi