EPROM Removal

[David A. Cooley]

Eric,
Did you see the memcal pic I put in the incoming directory?
Basically, I removed the ESC module, put it on a circuit board, ran wires 
to the pins on the MEMcal base where it came from and mounted a socket for 
the EPROM on top... Fit in the case just fine and made changing eproms a 
piece of cake!


At 07:03 PM 8/21/99 -0500, you wrote:

>It really wasnt all that hard, I didnt destroy the eprom, and it read just
>fine.  But I might have trouble getting it back together. I went through
>the archives for both gmecm and diy_efi, and found the connector you're
>talking about, but the solution was not very good in my opinion.  There
>would be no way for me to erase the eprom because mine must be closed to
>activate it.
>
>I will probably just fix my memcal and install a zif socket on it.
>
>-Eric
>

===========================================================
            David Cooley N5XMT           Internet: N5XMT at bellsouth.net
      Packet: N5XMT at KQ4LO.#INT.NC.USA.NA   T.A.P.R. Member #7068
    Sponges grow in the ocean... Wonder how deep it would be if they didn't?!
===========================================================