Intro

[David A. Cooley]

At 08:46 AM 2/7/99 -0600, you wrote:

> One thing I have always wanted to do, is to make the 7148 ecm
>programmable, kinda like a DFI. I do feel that the stock GN computer is
>capable of much more than people give it credit for. The biggest problem
>for me, is making changes to the program at the drag strip and the slow
>data stream for data logging. I am also looking at making a 7749 (syty)
>ECM work in a GN. I don't know if this really is a good move, but the
>lack of a MAF sensor and a faster data stream, makes it attractive to
>me. I would need it to work off of a 3 bar sensor too, since I would
>like to crank about 30 lbs of boost through this 6 cyl motor some day.

Hi Dan,
Good to see you here!
Just a quick note to let you know the Syty folks have been making 3 bar MAP
chips for some time now... I think they have the code on their page even...
www.syty.org.
Take care,
Dave

===========================================================
           David Cooley N5XMT           Internet: N5XMT at bellsouth.net
     Packet: N5XMT at KQ4LO.#INT.NC.USA.NA   T.A.P.R. Member #7068
       I am Pentium of Borg...division is futile...you will be approximated.
===========================================================