LT1 Prom editor project!

[Kurek, Larry]

> 
> Steve,
> 	I have already started it in Visual Basic 6.0. I am 
> making it table driven. At
> this point The tables are only internal. I need to see if I 
> can come up with
> generic enough displays to fit all years of LT1 ie 93-97. If 
> I can make it
> completely table driven I may spend the time to define the 
> tables and make them
> loadable. The PCM's with transmission control have a lot of 
> tables and scaling
> factors. If I were trying to just do a hex edit it would be 
> easy. I want to
> present values in understandable units, and the Hex value. 
> Even Table graph's
> where it makes sense.
> 
> 		Ken
> 

FWIW, the EEPROM ECM's were only used on 94-97 (LT1's...LS1's are a
different beast...), and the 94-95 were OBDI and the 96-97 were OBDII. As I
am sure you know, the LT1 was first used in 92 in the Vette's and the 92-93
used a removable PROM carrier, similiar to the previous generation ECM's.
Finally, the electronically controlled transmissions appeared in 94 as well,
so I assume the 94+ auto flash was significantly different than the 6speed
flash. Perhaps it would make more sense to disassemble a 6speed flash,
interpret it, and then go ahead with an auto?

TTYL!

Larry