EPROM emulator

[Bancherd(Mike) DeLong]

Yes, I do work with PIC's....can I help?  (I have been lurking trying to come
up to speed on auto-related issues....I am into circuit design, especially
ASIC)

Regards,

Bancherd(Mike) DeLong

jgwynne at mrcday.com wrote:

>    In message <36C2FC08.7C21A851 at mindspring.com>, you write:
>
> | Sounds good to me, too. I take it that the above design would be better
> | than this one:
> |
> | http://www.ldti.com/e46emu.htm
> |
> | Need any help, or do you already have a design/software? As previously
> | mentioned, I'm a decent hack with the parallel port and C...
> |
> | -Andrew
>
> I just took a quick look... it doesn't look to me like it will
> synchronously roll two banks in and out. I don't want to stop the
> engine... I want to do it in real time.
>
> YES!!! I need help!!! :). we need someone to lay the board out... I
> don't have those tools where I work now :(. The smallest processors I
> have are 68hc811's... are there any PIC users here? I really would like
> to do this through RS232... that avoids the linux/dos/etc issues... it
> will work with most anything then.
>
> john
>
> ---------------------------------------------------------
>                                 John S Gwynne, PhD.
> Mission Research Corporation    Email: jgwynne at mrcday.com
> 3975 Research Blvd              Tel: (937) 429-9261
> Dayton Ohio 45430-2625          Fax: (937) 429-2625
> ---------------------------------------------------------