'98 Vortec 350 - Good swap into a Jeep?

[CSH-HQ]

I'd srtongy suggest looking at the expertec GM training manuals.
there is some new stuff that you might nit be aware of,
Don't assume anything on this timing/fuel/ecm match.
Get the manuals first
Bruce


>I'm confused by all the comments on changing the intake,
>etc. Using a Non-OBD-II computer does not require
>changinging the intake manifold and Fuel system. Any of the
>TPI or later electronics could be used with the existing
>Intake. Some swaps are more difficult than others, For
>example: I put a 95 computer on my 96 LT1. It plugs right
>into the wiring harness, and only the Knock sensor has to be
>changed for compatability. What was the 95 computer used in
>chevy trucks? Is it compatable with the wiring harness?
>Using a 730 or 747 would be a lot more work because of all
>the custom wiring required, although you may be able to use
>the harness and most of the sensors off the old TPI system
>if the locations are similar.
>> There are a few tidbits about Ward's swap in the archives, but they're
>> only teasers at this point.
>> Go to the archives:
>> http://efi332.eng.ohio-state.edu/diy_efi/asearch.html
>> Type this in the subject line:  ECM wiring harness help
>> This should give you some ideas.
>> Shannen
>