What tables Do you edit

[Ken Kelly]

I'm looking for some advice. I'm writing an editor for the 94-95 LT1 PCM's.
There are many more tables in it than I know how to deal with, so far I have
implemented the following tables in the editor.

1) The bits for VAT, Speed Density, Traction contrl, AIR, etc.

2) Idle tables, Speed vs Temp, for in and out of gear

3) Ignition
	Load vs Adv 400-4000
	Load vs Adv over 4000
	Load vs Temperature vs Adv
	Cranking Adv vs Temp
	Closed Throttle Spark Advance vs RPM
	Minimum Spark Adv vs Temp

	Max Spark retard vs Load
	Max Spark retard vs RPM

	
4) Fuel
	Injector Size
	Cylinder Size
	Open Loop AFR vs Temp vs Load
	Power Enrichment vs Temp
	Power Enrichment vs RPM	
	%TPS for WOT vs RPM

5) Chassis

	Tire Size & Rear ratio
	Will add Fan temp set  points

My question is What tables do you edit? Which tables should I add. There are a
dozen other Fuel tables, which ones are important? Which tables do you usually
edit?

		Ken