What tables Do you edit

[Bruce Plecan]

> I'm looking for some advice. I'm writing an editor for the 94-95 LT1
PCM's.
> There are many more tables in it than I know how to deal with, so far I
have
> implemented the following tables in the editor.
>
> 1) The bits for VAT, Speed Density, Traction contrl, AIR, etc.

Yes, good.

> 2) Idle tables, Speed vs Temp, for in and out of gear

Absolutely

> 3) Ignition
> Load vs Adv 400-4000
> Load vs Adv over 4000
> Load vs Temperature vs Adv
> Cranking Adv vs Temp
> Closed Throttle Spark Advance vs RPM
> Minimum Spark Adv vs Temp
>
> Max Spark retard vs Load
> Max Spark retard vs RPM

Yes

> 4) Fuel
> Injector Size
> Cylinder Size
> Open Loop AFR vs Temp vs Load
> Power Enrichment vs Temp
> Power Enrichment vs RPM
> %TPS for WOT vs RPM

> 5) Chassis

> Tire Size & Rear ratio
> Will add Fan temp set  points

> My question is What tables do you edit? Which tables should I add. There
are a
> dozen other Fuel tables, which ones are important? Which tables do you
usually
> edit?

There are always a few that like to do everything, but I'd be happy with the
ones youe have currently listed.
With may be. AE to CTS correction
MAP/MAF scalers for switching MAF/MAPS.  Ranges/freguencies for either/and.
Switch setttings for VSS optional types if there.
Bruce
>
> Ken
>