What tables Do you edit

[Ken Kelly]

Bruce Plecan wrote:
> 
> > I'm looking for some advice. I'm writing an editor for the 94-95 LT1
> PCM's.
> > There are many more tables in it than I know how to deal with, so far I
> have
> > implemented the following tables in the editor.
> >
> > 1) The bits for VAT, Speed Density, Traction contrl, AIR, etc.
> 
> Yes, good.
> 
> > 2) Idle tables, Speed vs Temp, for in and out of gear
> 
> Absolutely
> 
> > 3) Ignition
> > Load vs Adv 400-4000
> > Load vs Adv over 4000
> > Load vs Temperature vs Adv
> > Cranking Adv vs Temp
> > Closed Throttle Spark Advance vs RPM
> > Minimum Spark Adv vs Temp
> >
> > Max Spark retard vs Load
> > Max Spark retard vs RPM
> 
> Yes
> 
> > 4) Fuel
> > Injector Size
> > Cylinder Size
> > Open Loop AFR vs Temp vs Load
> > Power Enrichment vs Temp
> > Power Enrichment vs RPM
> > %TPS for WOT vs RPM
> 
> > 5) Chassis
> 
> > Tire Size & Rear ratio
> > Will add Fan temp set  points
> 
> > My question is What tables do you edit? Which tables should I add. There
> are a
> > dozen other Fuel tables, which ones are important? Which tables do you
> usually
> > edit?
> 
> There are always a few that like to do everything, but I'd be happy with the
> ones youe have currently listed.
> With may be. AE to CTS correction
> MAP/MAF scalers for switching MAF/MAPS.  Ranges/freguencies for either/and.
> Switch setttings for VSS optional types if there.
> Bruce

Bruce,
	I have found the MAF vs Frequency table. It has 76 entries, and the ntries are
integer, not byte. I am writing some new code for this one. What is AE to CTS
correction? I don't recognize the term.

		Ken
> >
> > Ken
> >