CSH needed here too

[Mark Romans]

Same story here,  one relief was that I was pre-lubing the engine on the
engine stand.  Still had to pull the head and intake!
-----Original Message-----
From: Marc Piccioni <piccioni at cadvision.com>
To: 'gmecm at efi332.eng.ohio-state.edu' <gmecm at efi332.eng.ohio-state.edu>
Date: Friday, November 05, 1999 8:23 PM
Subject: RE: CSH needed here too


>1 large size needed...
>
>Rebuilt a 350 SBC, asked the machine shop to install all the pipe plugs
>etc. didn't check the workmanship. Finished assembling and installing the
>engine, on start up massive oil leak from the rear of # 7 cyl.,  3 hours
>later after removing A/C,  intake, & head I discovered the missing oil
>gallery plug that is just below the deck surface.....
>
>/Marc
>----------
>From: David Cooley[SMTP:n5xmt at bellsouth.net]
>Sent: November 5, 1999 9:08 AM
>To: gmecm at efi332.eng.ohio-state.edu
>Subject: Re: CSH needed here too
>
>I need an extra large...
>
>Rebuilt a QuadraJet and forgot to put the float in.
>Vent tubes went like a fountain!
>
>
>At 08:44 AM 11/5/1999 -0600, you wrote:
>>I'm qualified.
>>
>>Forgot to put rotor on when changing distributor cap.
>>Put eprom in backwards.
>>Forgot to hook vacuum line up to fuel pressure regulator.
>>Broke piston stop off inside cylinder.
>>Put tape over vacuum line to plug it...sucked it into engine.
>>
>>List keeps growing.
>>
>>Good judgment comes from experience.
>>Experience comes from bad judgment.
>>
>>Jim Sloan
>>leroy at sunflower.com
>>Lawrence, Kansas
>
>===========================================================
>David Cooley N5XMT Internet: N5XMT at bellsouth.net
>Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
>We are Borg... Prepare to be assimilated!
>===========================================================
>
>
>
>
>
>