165 UART chip (used for 8192 ALDL)

[Stuart Bunning]

I was offline for 1 week hang in there I will look for some stuff tonight..



At 01:56 pm 11/11/1999 +1100, you wrote:
 >
 >I would be interested to see the data sheets if they are available.
 >TIA
 >Matt
 >
 >mattpw at ozemail.com.au
 >-----Original Message-----
 >From: owner-gmecm at esl.eng.ohio-state.edu
 >[mailto:owner-gmecm at esl.eng.ohio-state.edu]On Behalf Of
 >vk265 at ozemail.com.au
 >Sent: Wednesday, November 10, 1999 6:02
 >To: gmecm at efi332.eng.ohio-state.edu
 >Subject: Re: 165 UART chip (used for 8192 ALDL)
 >
 >
 >It's not a UART......
 >
 >It's something very simular to a MAX232..
 >I have the full datasheets for this chip..
 >I got a them from the hourss mouth (delphi)
 >
 >here is the pinout..
 >
 >1,2,3,4,5,12,13,14,15,16,17,18,19,26,27,28  are all GND
 >
 >6 tx in
 >23 tx out
 >8 rx in
 >11 rx out
 >21,22 Vcc
 >24 tristate enable
 >
 >th other pins basically have caps and resistors hangind off them to setup
 >the internal filters for filtering out noise..
 >
 >apart from a few caps and resistors 11 in total to be exact... and of course
 >the power and ground wires.
 >there is only 3 wires that go from this chip U2 to the uP CPU .
 >
 >P.S

Best Regards,

STUART BUNNING
SALES ENGINEER
KENELEC SCIENTIFIC PTY LTD

23 REDLAND DRIVE
MITCHAM VICTORIA 3132
AUSTRALIA

PHONE:  61 3 9873 1022
FAX:    61 3 9873 0200
EMAIL:  stuart at kenelec.com.au
WEB:    http://www.kenelec.com.au/