When asking ecm questions

[JTesta1966 at aol.com]

In a message dated 10/23/99 2:47:16 PM Eastern Daylight Time, 
frederic at xephic.dynip.com writes:

<< Yes, you can.  A few wire movements on the ECM connectors, GN chip, and
 its good to go.  Ran the GN code on a FWD engine, and GN code on a RWD
 4.1L block I converted into a twin-turbo engine.  The stock GN code
 didn't run that g >>

Ahh..ok..I'd need to move wires. No that wont work. I wanted to have a spare 
ECM or two for using Direct Scan in guys cars at the track is all. (Without 
disassembling MY car to remove the ECM)

Thanks :-)
Jim