was beating horses..now maf flow
Mike Rolica
mrolica at meridian-mag.com
Fri Oct 29 16:53:37 GMT 1999
Hey, I'm wondering if I'm starting to out flow my MAF. Speaking of the
subject How high can they read? And can I fix it? Maybe that is why motor
suddenly drops off like rock at 5000 and goes little lean...Any calculations
on this?
Mike Rolica
EXT. 260
:-)
-----Original Message-----
From: nacelp at jvlnet.com [SMTP:nacelp at jvlnet.com]
Sent: Friday, October 29, 1999 12:12 PM
To: gmecm at efi332.eng.ohio-state.edu; GM EFI List
Subject: Re: Hello/Beat that dead horse again!
Well, I got some good news an some bad news.
Eight 30 lb/hr injectors it a total flow of 240 lbs/hr, at .5 per HP
that's 480, and heated of the intake air from the S/C might drop
that.
Doing chips once past the intial time to read up, and get the
equipment
isn't that hard, and for cuustom stuff you can get your investment
back
quickly. Plus your not always waiting for the mailman.
Really on something like that/this getting the car to someone with
a
diacom, and doing a custom chip would be the only really right way
Also, it will never be 100% right. What you have outflow the MAF by
a large
margin so WOT is going to be a compromise.
Where is Clarksville?. Is that where the shop is?....
I might be of some help inna week or so..
Grumpy
More information about the Gmecm
mailing list