ONE WIRE O2 TO HEATED O2

[David Cooley]

At 12:32 PM 4/8/00, you wrote:
>Just a quick question. Has anyone converted the one wire O2 Sensor in 
>their GM EFI system to Heated O2 design I having a problem with going into 
>open loop when I come to a stop because the O2 cools off to much being in 
>my Header and I can't move it anyplace else. If you have could you give me 
>a little insight on what it entails.


Hi Todd,
A lot of the Buick GN owners have done this.
Consists of having to make up a connector for the new O2, running a ground 
to the heater, and switched 12V to the heater.  Connect the signal out to 
your existing O2 wire.


===========================================================
David Cooley N5XMT Internet: N5XMT at bellsouth.net
Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
We are Borg... Prepare to be assimilated!
===========================================================

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org