manifold machining

[David Cooley]

At 02:09 AM 4/9/00, you wrote:
>Peter Gargano is planning an AlfaSud EFI conversion:
>(complete quotation below)
>
>>. . . because then I can add a fancy manifold, perhaps going through a 
>>few iterations . . .
>
><Beavis_And_Butthead>Fancy manifolds are cool!</Beavis_And_Butthead>
>
>>My only concern was that, as injector is close to the inlet valve, and in 
>>the head itself, that the O-ring or injector may get too hot in this 
>>position (it's a cross flow head - exhaust manifold is on other side from 
>>injector).

The Buick 3800 Supercharged version mounts the injectors in the 
head.  Might get some of their O-Rings.

===========================================================
David Cooley N5XMT Internet: N5XMT at bellsouth.net
Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
We are Borg... Prepare to be assimilated!
===========================================================

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org