Was Chip carrier now sockets

[Ludis Langens]

steve ravet wrote:
> 
> Maybe someone could design a little board with rows of single header
> pins at 0.4" or whatever to plug into the ECM, and .6" holes for a ZIF
> or other socket.  Would be much cheaper than buying little plastic
> things.

I measured the spacing in my '7748:  0.475".

I also checked several C3's with 24 pin EPROMs.  They were all the
standard 0.6".  Hmmm.  The 24 pin and 28 pin R&N chip holders look
identical (except for the number of pins.)  The 28 pin bases must be
different.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org