laptop scantool.

[ECMnut at aol.com]

Hi Greg,
your ecm should be a 8192 baud, being that new.
Mike V

In a message dated 8/10/00 12:23:06 AM Eastern Daylight Time, 
gruegre at hotmail.com writes:

> 
>  Also, I've read that some ECMs are capable of the 160 baud and the 8132 
(??)
>  baud.  I took the liberty of running my multimeter on the E pin and I saw
>  some output just as I thought I would.  I ran it again on pin M not knowing
>  if there would be higher baud rate output.  I didn't see anything, but my
>  DVM is very old and has terrible refresh rate.  I'm assuming I only have 
160
>  baud output.  If it turns out that I do have both, can I use either?
>  
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org