7730/ANHT code problem

[Mike Rolica]

There is a COUPLE OF OTHER THINGS THAT YOU WILL HAVE TO CHANGE AS WELL
.  ive succesfully use it on a number of vehicles...
You will want to make sure that you are using a 4cyl memcal for a 730, as it
can put a wrench in things...
I used a 4cyl memcal, and burned the 8d image onto the chip

At $6DD your cyl volume should be changed to reflect the engine size.
At $824, you inj flow rate shoul be changed also..
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 244



	-----Original Message-----
	From:	chetwagner at uswest.net [SMTP:chetwagner at uswest.net]
	Sent:	Thursday, August 17, 2000 10:26 PM
	To:	gmecm at diy-efi.org
	Subject:	7730/ANHT code problem

	Just for starters, I am in the middle of a conversion that will be 
	using the 7730 and hopefully the ANHT/AUJP code.  That is if I can 
	figure out why the cyl select function in the code does not work.  
	No mater what the setting is set to, the engine doesn't run very
well 
	and the scantool always shows the rpm as if the engine is a 
	V8(this is a four cyl engine it is going on).  I do not know how to 
	read any of the code that is on the chip besides the data tables, 
	but maybe someone who does would be able to help me.  It almost 
	seems like the code was made specifically for the V8 and nothing 
	else.  Please help, any little bit is more than I have.  
	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org