Needed to measure AFR

[Mike Rolica]

02 sensor is not working then.. will not be hot enough... even if heated...
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 244



	-----Original Message-----
	From:	alexpeper [SMTP:alexpeper at email.msn.com]
	Sent:	Monday, August 21, 2000 1:22 PM
	To:	gmecm at diy-efi.org
	Subject:	Re: Needed to measure AFR

	6:1 for cold start and warm up.
	Alex
	----- Original Message -----
	From: Greg Hermann <bearbvd at cmn.net>
	To: <gmecm at diy-efi.org>
	Sent: Saturday, August 19, 2000 11:54 PM
	Subject: Re: Needed to measure AFR


	> At 12:00 AM 8/20/00, Bruce Plecan wrote:
	> >What range of AFR is really used in a common EFI engine
	> >I'd think 15.5:1 to 11.5:1 would have to cover the
	practical limit,
	> >yes-no?..
	> >For conventional engines.
	> >Bruce
	>
	> I would say go up to 16.5 or 17 to 1---this lean is useful
	for lean cruise.
	> Otherwise fine.
	>
	> Greg
	>
	>
	> ----------------------------------------------------------
	------------------
	> To unsubscribe from gmecm, send "unsubscribe gmecm"
	(without the quotes)
	> in the body of a message (not the subject) to
	majordomo at lists.diy-efi.org
	>



	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org