converting a GM non computer hei distributor to a computer hei

[Bruce Plecan]

Weld
Any thing that has any slop, or place for any slop to develope is subject to
Murhpy's laws/
Bruce

From: "Bob Valentine" <bob at tecmark.com>
> I'll bet the rotor will move just enough to cause a headache if you just
> yank the weights and leave "strong" springs in as shown below.  Either
weld
> it or lock it down with a small nut and bolt.
> -> Bob Valentine
> -> bob at tecmark.com
> At 01:59 PM 12/11/2000 EST, you wrote:
> >Diane,
> >Go to http://members.aol.com/weg1192/sparktuning.html
> >If this doesn't answer all your questions, email me off list.
> >JW

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org