Fw: Hiway for the '747

[Kevin R]

So as long as the that location was originally 0 on the base prom I started
with, the section that was replaced would have never been accessed/used
anyway!?

Anything else special to look for when setting up the new hiway mode, or
just re enable it in the bin and set the parameters specified?

Kevin R


> The fuel portion replaces the open-loop decel code. I
> meant to put this in the .txt file. . . If location
> 0xD006, bit 3 of the eprom is 0, then the replaced code
> is not used. I have found that some big block cals use
> this code.
>
> Note that the AFR tbl ends up in code space, so it is
> replacing some of the opn lp decel code.
>
> BobR.


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org