starting point L-plates

[Bruce Plecan]

  The Buick is a MAF system using a crank (3 slot) and cam shaft posistion sensor.
  The syclone is a MAP system using a distributor.
  Which most closely matches what you have?
  You need to run a 2 bar MAP sensor.
  Is you 16183082 similiar to any USA ecm?.
  Can you use a 808, is your 082 a 128K prom?.
  Grumpy


  You see, I am wanting to convert my Nissan system over to delco,ecm sensors,etc from a VR V6 ,16183082 ,
  I have a 3 liter turbo engine , (was thinking that if I could get maps,program out of a V6 turbo buick gn it would be a better starting point than nothing) ,Will this work???? or am I going to have to modify the program from the N/A V6 ????
  My turbo boost is 15psi, so I know a modified MAP sensor is on the list, 
  I am only a beginner  ,(although I am a mechanic,tinker with electronics,basic asm programming the 6502/z80)
  my main interest in the delco ecm is in real-time programming, (Its a must!)
  bye for now        
  Paul

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.diy-efi.org/pipermail/gmecm/attachments/20000115/c0f1074e/attachment.html>