Spark Reference Angle for 8 pin HEI module

[Bruce Plecan]

If your running a distributor then just run 0, if the donor vehicle was a
distributor.
It gets sticky with the module/sensors using the crank/cam sensors.  One
version is 60 the other 70 d..   If you look at the various 5D mask 808s
you'll see the difference from  a dissy to DIS, easily.
Grumpy



| Hello
| I am using a 808 ECM  and a 8 pin HEI module on a straight 6 chrysler
| motor. (custom EFI setup)
| I have attached a gif of the hei module i'm using.. It's found on a 4
| cylinder GM car a camira in australia.
| I beleive it's the same module on some chev v8's in USA..
| I was wondering what Spark Reference angle I should use in my Binary.
| as I have no reference because this motor has never been produced with EFI
| on it before and this module has not been used
| on that motor before..
| Stuart Bunning