Syncing crossfire injection

[Dave Zug]

large face (5")  0 - 10" wc guages are in mech rooms everywhere that I retrofit systems. not very large graduations (60 degree sweep too) but if this will do some good for someone I'll start collecting them... let me know.  
----- Original Message ----- 
  From: Ken Kelly 
  To: gmecm at efi332.eng.ohio-state.edu 
  Sent: Monday, January 17, 2000 5:42 PM
  Subject: RE: Syncing crossfire injection


  Nope, you'll need a gauge that measures in inches of water. Both TBI's need to be sync'ed at 6" of water. 1 inch of mercury is equal to about 40" of water. If you need a gauge, let me know, I have a few extras I'm willing to sell.
   
  Ken
    -----Original Message-----
    From: owner-gmecm at esl.eng.ohio-state.edu [mailto:owner-gmecm at esl.eng.ohio-state.edu]On Behalf Of Kevin Reynolds
    Sent: Monday, January 17, 2000 1:51 PM
    To: gmecm at efi332.eng.ohio-state.edu
    Subject: Syncing crossfire injection


    I want to check the synchronization of my crossfire injection, but don't have a manometer.
    Is a map sensor connected to a DVM sensitive enough to use for this?
    Any other ideas?
    Kevin R
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.diy-efi.org/pipermail/gmecm/attachments/20000118/f0aee736/attachment.html>