IAC parameters

[Ludis Langens]

Barry Tisdale wrote:
> 
> Per the ALDL data stream, injectors are firing, but
> injector hooked to the output line(s) does *not* fire.  Maybe *all* the
> sensors need to be connected??

You do have the injector ground jumper(s) installed, right?

The injector driver doesn't connect to ground internally.  Instead, the
circuit is brought out to pins D6&D7 and C13.  You need to connect those
to ground, or to the P+H current sense pins (which internally ground
through a 0.1 ohm resistor.)

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org